Orion Motor Tech 5-in-1 Ball Joint Separator, Pitman Arm Puller, Tie Rod End Tool Set for Front End Service, Splitter Removal Kit (RB06)

Used these to replace my inner and outer tie rods. The ball joints were seized and I was afraid to take a hammer to them. Took less than five minutes to pop them free with this tool.It's one of those tools where the amount of energy saved far outweighs the cost of the product.

good product with good quality

muy eficiente muy funcional

EDIT-updated from 2 star to 5 starI reached out to OMT directly about the broken tools and they responded quickly. They shipped out a replacement with a lead time "around 3-7 business days". It arrived the very next day.I was finally able to pull the pitman arm after 2 weeks of wrestling with it. It was rusted in place but these tools broke it free. I'm leaving my original review below for reference. I'm not sure if was user error or faulty tools, but OMT came through in the end.ORIGINAL REVIEW:Four of the five tools broke while using them. The 5th tool (separator) only survived because it wouldn't fit around any of the ball joints on my 1992 Toyota Century. The large claw puller was able to move the pitman arm down a few mm before cracking.I used an obscene amount of silicone grease on the threads. I didn't use an impact wrench. The joints have been sprayed with PB Blaster several times daily for about a week. I did everything I could to give these tools a fighting chance and they still broke.The large adjustable puller bent out of alignment on the first try. The arms are no longer even and do not sit flat making it useless. The bolt on the smallest puller sheared when I used a tube as a breaker extension. I had to use a hacksaw to cut it free.The large puller was the perfect size for the pitman arm. I went super slow with the tube extension, tightening a half turn or so before backing off, hosing the steering column down with penetrating fluid, and then tightening it again. Using this process, it moved a few mm before the claw snapped. I tried my luck separating the ball joint side of the pitman arm with the small puller. Using only a wrench (no extension) the claws began to bend backwards.I expected a little bit of a hassle when using these. Even one broken tool would've been understandable, but four? The metal used is of terrible quality. I do not recommend.

Worked exactly as advertised. Great product. Made my work much easier.research your selections

Product was needed to complete my project.It worked as listed.Made it very easy for me.Thanks again.

Awesome Tool

Very cheap. Don't waste your money on this product. 2 of the tools in the box broke or got damaged on the first use. Would return if immediately.